8 points to pay attention to when using tinned copper wire

Buck Copper industry specializes in the production and processing of tinned copper wire, our various types of products fully meet the requirements of wire and cable industry, can be customized according to customer requirements. To understand the use of tinned copper wire precautions are as follows:

1. Spools that are not used up by tinned copper wire should be placed in the original packaging box, and should not be placed at will. The label should be protected in its original state.

2, when necessary, please use partition board to support the pile height of the spool to avoid the adverse effects such as dampness.

3. When taking the spool, it should be taken out vertically to avoid the knock and injury of the wire, and pay attention to the collapse of the left and right lines.

4, the unused wire must be wrapped tightly, not loose on the spool.

5. The paint film on the surface of tinned copper wire is very thin and easy to be bruised by external forces. In the process of transportation or movement, special attention should be paid to handling with care to avoid dumping collision and ensure that the wire is not damaged.

6, winding operation, tinned copper wire paint film is easy to be scratched by metal and other hard edge. In the process of winding, should pay close attention to winding machine and tinned copper wire contact parts, reduce the unnecessary external force imposed on the tinned copper wire, to avoid quality deterioration. If accidentally caused knock injury or multiple threads, the part can be cut off with pliers and removed, and then used to the normal part. The wiring device that affects the quality of the line should be thoroughly improved as soon as possible.

7. Wire tension should be controlled within the safe tension during winding operation, and the size of the force should be adjusted according to the actual situation of production. When winding, wear latex fingercovers if hand must contact tinned copper wire directly. Before winding, check whether the outer edge of the reel is smooth without barbs to avoid injury to the tinned copper wire. When winding to the bottom of the barrel, moderate deceleration should be carried out to avoid the danger caused by twisting or knotting at the end of high-speed winding.

8, solder copper wire operation, the paint film will decompose harmful gas, so the operation site should be installed forced exhaust device.